Minolta magicolor 2210 Instalační příručka stáhnout pdf (Strana 20)

Plugging in/Turning on the Printer16

English

Plugging in/Turning on the Printer

Make sure

the printer is

turned off.

Plug the printer

power cord into the

printer and into the

dedicated,

grounded,

surge-protected

electrical outlet.

WARNING!

Do not overload the outlet. For products installed outside North

America, do not connect the groundwire to gas or water pipes or

grounding for telephones.

Turn on the printer.

In compliance with UL guidelines, “The appliance inlet is con-

sidered to be the main disconnect device.”

After a brief warmup, your printer prints a startup page and displays

“

IDLE

” on the message window. If “

IDLE

” is not displayed in the

message window after the power switch is turned on, the setup oper-

ation is not proceeding correctly or the printer may be malfunctioning.

Recheck the setup. If the startup page doesn’t print or the print qual-

ity is not good, skip ahead to “Troubleshooting” on page 32.

The printer automatically switches to power-saving mode after

30 minutes of inactivity. In the Administration/Engine/Energy

Saver menu, you can change the number of minutes before the

printer switches to power-saving mode.

EDNord - Istedgade 37A - 9000 Aalborg - telefon 96333500

1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 47 48

Žádné komentáře

Minolta magicolor 2210 Instalační příručka Strana 20